JVC LM-17G - Manual (Page 12)

11
ENGLISH
SYSTEM SETTING menu
SYSTEM SETTING
Exit
SIGNAL LEVEL
DISPLAY
OSD POSITION
COLOR SYSTEM
AGC
REMOTE
All reset
SIGNAL LEVEL: You can choose the signal level from ”STD.” or “AMP.”.
STD.: Select this for normal operation.
AMP.: Select this to watch dark part of the picture better.
DISPLAY: If you select ‘ DISPLAY ’ and press the ‘ MENU/ENTER ’ button, you can confirm the current status;
resolution, Horizontal frequency and Vertical frequency.
COLOR SYSTEM: You can choose the color system from NTSC, PAL, BW60 or BW50. Choose the correct color
system when the color is abnormal or no color appears.
AGC: You can turn the AGC (Auto Gain Control) function on (ON) or off (OFF).If you select off(OFF), you can adjust
contrast bar.
REMOTE: If you select ON, you can only do remote control. If you select OFF, you can control only by using the
monitor’s buttons.
Exit: If you select “Exit” and press the ‘ MENU/ENTER ’ button, the menu will disappear.
All reset: If you select “All reset” and press the ‘ MENU/ENTER ’ button, the settings will be return to the factory
settings.
* “COLOR SYSTEM” and the input select will not be return to the factory settings.
OSD POSITION:
You can adjust the position of the menu on the screen as following procedure.
1. Select “OSD POSITION” and press the ‘ MENU/ENTER ’ button, the sub-menu will appear.
2. Press ‘UP’ and ‘DOWN’ button to choose “H. POSITION” (horizontal position) or “V. POSITION” (vertical
position), and then press ‘ MENU/ENTER ’ button to display the adjusting menu
3. Press ‘UP’ and ‘DOWN’ button to adjust the position of the menu on the screen.
4. Press ‘ MENU/ENTER ’ button to return to the “OSD POSITION” menu.
Next page: If you select ‘ Next page ’ and press the ‘ MENU/ENTER ’ button, the next menu will appear.
CONTRAST menu
You can adjust the contrast of the image from the PC.
OSD POSITION
Next page
H. POSITION
V. POSITION
CONTRAST
－
＋ 50