Jet Tools JWBS-20 - Manual (Page 5)

5
Contents of Shipping Container
1. Bandsaw
1. Table
1. Fence and Rail Assembly
1. Resaw Guide and Knob
1. Miter Gauge
1. Owner’s Manual
1. Warranty Card
1. Hardware Package
2.
Knobs
1. Hex Wrench
1. Handle
1. 10/12mm Wrench
1. Fence Hardware Bag
4.
Hex Cap Screws
4. Flat Washers
4. Lock Washer
1. Rail Hardware Bag
9.
Hex Cap Screws
9. Flat Washers
9. Lock Washers
Unpacking and Setup
1. Remove the crate and packing material
from the saw except for the transport skid
on the bottom.
2. Move the saw to its permanent working
location. The site should be dry, well lit, and
have enough room to handle long stock and
the
service and/or adjustment of the
machine from any side.
3. Move the bandsaw off the skid.
4. Clean all rust protected surfaces with a mild
solvent or diesel fuel and a soft cloth. Do
not use lacquer thinner, paint thinner, or
gasoline.
These will damage painted
surfaces.
Tools Included for Assembly
1. 10/12mm Open End Wrench
1. Hex Wrench
Tools Required for Assembly &
Adjustments
2. 14mm Open End Wrench
1. Cross Point Screw Driver
1. Combination Square