JVC DT-V24G1 - Manual (Page 12)

12 Menu Configuration—MAIN MENU
PICTURE FUNCTION
Setting for the picture quality
Item To do Setting value
APERTURE FREQ.* 1 Select the frequency of the luminance signal compensated in
“APERTURE LEVEL.” OFF, LOW, HIGH
APERTURE
LEVEL*
1
Compensate the frequency response of the luminance signal of
the video signal. 01 – 10
CTI Adjust the clearness of the outlines of the chrominance signal. OFF, NORMAL,
HARD
LTI Adjust the clearness of the outlines of the luminance signal. OFF, NORMAL,
HARD
I/P MODE Selects a proper mode corresponding to the input picture. NORMAL, CINEMA,
FIELD
sub menu Display the sub menu which enables you to adjust the items of “PICTURE FUNCTION”
while viewing the actual picture.
reset Restore the default settings for all the items in “PICTURE FUNCTION.”
* 1 Memorized for each input.
BACK LIGHT
Adjusts the brightness of the display.
3G SDI LEVEL B
Selects the data stream from two HD SDI signals multiplexed when a 3G SDI level B signal comes in.
SDI DUAL LINK
Activates/deactivates the DUAL LINK function of SDI signals.
• “DUAL LINK” is displayed when the setting is set to “ON.” No other status indications of SDI signals are
displayed.
• Set this setting to “OFF” when an SDI signal other than DUAL LINK SDI is input.
COMPO./RGB SEL.
Selects the signal type you want to use for COMPO./RGB terminals.
Operation guide
Shows the buttons for each operation.
For the operation procedure, see page 7.
• The menu automatically disappears in about 30 seconds after the previous operation.
• Some items may not appear on the menu depending on the input or the input signal.
• The items controlled by the MAKE system do not appear on the menu.
Setting value: –20 – +20
Setting value: DS1, DS2
Setting value: OFF, ON
Setting value: COMPO. (COMPONENT), RGB
DT-V24G1_20L3G_EN.indd 12 DT-V24G1_20L3G_EN.indd 12 10.1.15 3:22:20 PM 10.1.15 3:22:20 PM