JVC DOME CAMERA VN-C215V4U - Manual (Page 22)

22
Setup
Mount by allowing the cable to exit from
the side
You can also mount the camera on a ceiling or
wall by pulling the cables horizontally instead of
drilling a hole.
The basic mounting method is the same as
eMounting the camera directly on a ceiling or
alongside a wall
f (A Pg. 20).
1.
Remove the lid of the cable ejector hole
and divide the dotted line section of the lid
with a longnose pliers.
2.
Mount the outer case on the ceiling or
wall.
3.
Pull out the cables from the cable ejector
hole.
4.
Connect the cables. ( A Pg. 20)
5.
Close the lid of the cable ejector hole.
Mounting the camera to the electrical
box
Note：
● Before mounting the camera to electrical
boxes, please refer to local building codes for
box type to use for low-voltage wiring.
Ⅵ Connecting
1.
Align ( j) with the shooting direction when
mounting the outer case to the electrical box
2.
Follow steps 2 to 6 of AMount by allowing
the cable to exit from the side B[Connection]
( A Pg. 20)
Mounting the Camera
(continued)
1
2
Divide
Cable ejector hole
5
FRO
NT UP
Outer case
mounting screws
Align with shooting direction
Less than 3 mm
VN-C215_EN.book Page 22 Monday, November 27, 2006 9:52 AM