JVC RX-665VBK - Manual (Page 38)

35
English
Notes:
• The sound levels of the left and
right rear speakers will be the
same.
• You cannot set the sound level
of the rear speakers when you
have selected “3CHLOGIC.”
• You cannot set the sound level
of the center speaker when you
select “PHANTOM” for the
center mode.
9. If necessary, adjust the speaker output balance as
follows:
• To adjust the rear speaker output level, press Control
5 / ∞ until “– REAR +” appears on the display, then
press Control
2 / 3.
• To adjust the center speaker output level, press
Control 5 / ∞ until “–CENTER+” appears on the
display, then press Control
2 / 3.
10. Press Control 5 5 5 5 5 / ∞ ∞ ∞ ∞ ∞ until “TEST” appears on the
display, then press Control 2 2 2 2 2 / 3 3 3 3 3 twice to stop the
test tone.
If you have selected JVC Theater Surround, go to the following steps.
11. Press Control 5 5 5 5 5 / ∞ ∞ ∞ ∞ ∞ until “–EFFECT+” appears on
the display.
12. Press Control 2 2 2 2 2 / 3 3 3 3 3 to adjust the effect level.
Each time you press the button, the effect level changes
as follows:
As the number increases, the effect of the Theater Surround becomes stronger.
From the remote control:
If you have already set the center speaker size following the procedure described on
page 19, you can use the remote control for surround mode preparation.
1. Press SOUND CONTROL so that 10 keys work for
adjusting the sound.
2. Press SURROUND until the Surround mode you
want appears on the display.
The previous mode is recalled (with its previous
settings) and is shown on the display.
The indicator for that mode also lights up on the display.
Each time you press the button, the Surround modes
change as follows:
3. Press DELAY to adjust the delay time of the rear
speaker output.
Each time you press the button, the delay time changes
as follows:
Using the Surround Processor
EFFECT 1 EFFECT 2
EFFECT 4
EFFECT 3
EFFECT 5
3
SURROUND
SOUND
CONTROL
5
DELAY
DELAY 1 DELAY 2 DELAY 3
PROLOGIC THEATER 3CHLOGIC
OFF
Note:
When you have selected
“3CHLOGIC” or “THEATER,” you
cannot adjust the delay time.
Note:
When you have selected
“PROLOGIC” or “3CHLOGIC,”
you cannot select the effect level.
RX-665VBK(C)24-50 98.5.12, 11:30 AM 35