JBL NO TOUR IBT - Manual (Page 5)

5 www.jbl.com
E
ng
lis
h
VOluMe cOnTrOls
Volume increase “+”
Volume decrease “–”
Phone button “ ”
Microphone “ ”
baTTery InsTallaTIOn
1. Rotate the battery compartment cover on the bottom of the JBL
On Tour iBT speaker to the unlocked position; remove the battery
compartment cover.
2. Place (4) fresh AA batteries as shown.
3. Replace the battery compartment cover.
note: The JBL On Tour iBT will not use battery power when using AC
power.
1. 2. 3.
DO NOT MIX BATTERY TYPES.
DO NOT MIX CHARGED AND PARTIALLY CHARGED BATTERIES.
BATTERIES WILL NOT RECHARGE WHILE IN THE UNIT.
baTTery dIspOsal
Alkaline batteries are considered nonhazardous. Rechargeable batteries
(i.e., nickel cadmium, nickel metal-hydride, lithium and lithiumion)
are considered hazardous household materials and may pose an
unnecessary health and safety risk.
In the European Union and other locations, it is illegal to dispose of any
battery with household trash. All batteries must be disposed of in an
environmentally sound manner. Contact your local waste management
offcials for information regarding the environmentally sound collection,
recycling and disposal of used batteries.
Bluetooth paIrInG
Before you can use your JBL On Tour iBT system with a Bluetooth-
enabled device, you must pair it with that device.
To pair the JBL On Tour iBT with your device:
1. Make sure your JBL On Tour iBT system is turned on. The JBL On
Tour iBT unit automatically goes into Pairing/Discoverable mode,
represented by the Source LED flashing blue.
2. Put your Bluetooth-enabled device in Pairing mode so both devices can
“see” each other. (Refer to the Bluetooth-enabled device’s user’s guide
for directions and details about putting it into Pairing mode.) The JBL On
Tour iBT unit will be represented as “JBL On Tour iBT” on your Bluetooth-
enabled device. The JBL On Tour iBT password is 0000.
3. The JBL On Tour iBT system is successfully paired and ready to use
when the Source LED glows a constant blue.
note: Bluetooth pairing between two devices does not have to be repeated
after a successful initial pairing, unless the JBL On Tour iBT system has been
removed from the Bluetooth-enabled device’s Bluetooth device list. cautIon: Risk of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.