JVC SR-DVM700E - Manual (Page 49)

Masterpage:Right+
EN
49
Filename [DVM700EU_11Editing.fm]
EDITING
Page 49 Monday, 13 March 2006 15:07
● If the dubbing is paused while the channel is set to ADVB, you
cannot switch channels.
To skip unwanted part of the source picture
Press ENTER to stop both equipment, then press selection keys
to select
.
Locate the point where you want to restart dubbing by pressing I,
N, or O, then press o.
Press selection keys to select
, then press ENTER to
restart dubbing.
Recording Mode
MPEG2 format is used as recording format. As a guide for picture
quality, the
AbpsB unit is used to represent how much data can be
recorded per second. The larger this value is, the better the picture
quality becomes but more capacity is required for the recording.
Select XP or SP for programmes where quick movement occurs,
such as sports programmes, and LP or EP for talk shows, etc. with
relatively less movement.
The recording modes for a 4.7 GB disc are set as follows:
● For details on FR mode, refer to AFree Rate FunctionB on the
right column.
The recording modes for the HDD are set as follows:
● For details on FR mode, refer to AFree Rate FunctionB.
NOTE:
The maximum recording time stated in the above table are the
approximate time under unused condition.
Free Rate Function
To record the entire programme, the unit automatically sets the
appropriate recording mode depending on the combination of the
total time of the programme to be recorded and either the
remaining disc space or the specified recording time (from 60
minutes to 480 minutes).
8 To record the entire programme within the actual remaining
disc space (DVD deck only)
Select AFR (JUST)B in a recording mode selection procedure.
● Note that this function is available only when dubbing from HDD
to DVD (
A pg. 44).
8 To record the entire programme by specifying the desired
recording time
Select AFR60–FR360B, AFR420B or AFR480B in a recording mode
selection procedure.
8 To record a 25-min. long programme five times on the same
DVD disc for example
Be sure to set the recording mode to AFR125B to fit the total
recording time to the whole disc space.
When the same programme is recorded in SP mode instead of in
AFR125B, the 5th programme cannot be recorded.
NOTES:
● The maximum recording time of FR (JUST) mode is the same as
the recording time of FR480 mode. When dubbing a long
programme in FR (JUST) mode on a disc whose remaining time
is short, it is recommended to check the disc remaining time in
FR480 mode to see if the remaining time is enough for the
programme.
● In order to ensure that the recording fits on the disc, this feature
may leave a slight non-recorded section at the end of the disc.
● There may be some noise and sound disturbance at the point on
the disc where the unit switches the mode.
When you dub from DV equipment other than a
camcorder
A Perform step 1 to 4.
B Locate the point from where you want to start dubbing,
then stop on the DV equipment.
● If you pause the DV equipment in this step, a few
second’s still picture will be recorded at the beginning of
the recorded programme.
C Set the input mode to ADV INPUTB on the DV equipment.
● If you select an input mode other than ADV INPUTB,
unwanted pictures may be recorded at the beginning of
the recorded programme.
D Perform step 9 to 12.
Recording mode Recording amount
(approx.)
Maximum recording
time (approx.)
XP 10 Mbps 1 hour
SP 5 Mbps 2 hours
LP 2.5 Mbps 4 hours
EP 1.6 Mbps 6 hours
FR
60-360
The amount varies
depending on the
selected time.
1 – 6 hours
420 7 hours
480 8 hours
Recording mode Maximum recording time (approx.)
DV 18 hours
XP 53 hours
SP 109 hours
LP 218 hours
EP 328 hours
FR480 473 hours
Blank
A: 1st
B: 2nd
C: 3rd
D: 4th
E: 5th
A: 1st
B: 2nd
C: 3rd
D: 4th
E: Blank (20 min.)
Blank
DVM700EU_00.book Page 49 Monday, March 13, 2006 3:07 PM