Operation, B. 30 minute temperature control, Operation of your 30 minute temperature control – Jacuzzi SteamPro User Manual
Page 15: Temperature adjustment
OPERATION
B. 30 MINUTE TEMPERATURE CONTROL
The 30 minute temperature control features a 30 minute press on timer lighting
up the word "STEAM" and a thermostatic control preset to reach 120 degrees
Fahrenheit. The digital control can be mounted either inside or outside the
steam room. The preset temperature can be adjusted in a range between
100 degrees and 125 degrees Fahrenheit. Once the set temperature is
reached the ''soft steam'' feature automatically engages cutting steam
production back to a single element to provide softer billowing steam during
more of the steam bath. If the steam room temperature drops more than 5
degrees both elements will automatically engage.
Operation of Your 30 Minute Temperature Control
1. Be sure the power circuit and water supply to the generator are on.
2. Firmly press the ON/OFF button on the control until the word “STEAM” lights up.
3. The generator should produce steam in 5 to 10 minutes and will turn off automatically in 30 minutes. You may
also press the control a second time to turn off the “STEAM” light and shut down the generator.
4. If you wish to change the preset temperature see the instructions in below.
Temperature Adjustment
1. To adjust the set temperature remove the snap-on decorative control cover by lifting from the bottom as shown
in diagram.
2. Using a small slotted screw driver turn the adjustment pot in the desired direction. See diagram. One quarter
turn equals approximately 5 degrees of temperature change. Caution: Over stressing the adjustment pot can
damage the control.
3. Snap the control cover plate back on by sliding the top of the cover plate onto the control housing and pushing
on the bottom of the control cover plate. See diagram. The new temperature setting will become effective the
next time the steam is turned on.
2
WALL
DECORATIVE CONTROL
COVER PLATE
CONTROL
HOUSING
13