Troubleshooting – JVC LYT1341-001B EN User Manual
Page 33
REFERENCES
EN
33
MasterPage: Reference_Right
Power
No power is supplied.
● The power is not connected properly.
H
Connect the AC Adapter securely.
● The battery pack is not attached firmly.
H Detach the battery pack once again and re-attach it firmly.
● The battery is dead.
H Replace the dead battery with a fully charged one.
Recording
Recording cannot be performed.
● [MEMORY CARD IS FULL] appears.
H Replace with new recording medium or delete unnecessary
files. (
● Recording medium is not selected properly.
H Select the recording medium. (
● The rear panel is open.
H Close the cover and set the power switch to OFF, then to
.
When shooting a subject illuminated by bright light,
vertical lines appear.
● This is not a malfunction.
When the screen is under direct sunlight during
shooting, the screen becomes red or black for an
instant.
● This is not a malfunction.
During recording, the date/time does not appear.
● [DATE/TIME] is set to [OFF].
H Set [DATE/TIME] to [ON]. (
The LCD monitor indications blink.
● Certain modes of wipe/fader, program AE, effect, DIS and
other functions that cannot be used together are selected at
the same time.
Digital zoom does not work.
● [ZOOM] is set to [10X] (optical zoom).
H Set [ZOOM] to [40X] or [200X]. (
੬ pg. 28)
Playback
Playback cannot be performed.
● Recording medium is not selected properly.
H Select the recording medium. (
● The rear panel is open.
H Close the cover and set the power switch to OFF, then to
.
● Playback starts, but there is no picture on TV.
H Set the TV's input mode or channel appropriate for video
playback.
The same image is displayed for a long time during
video playback, or motion is choppy.
There are periods of silence during voice playback.
● If the surface of the hard disk is damaged, it makes difficult
to read data and these phenomena will appear. This
camera will make all possible efforts to read data, but when
such a state continues for some time, and further playback
is impossible, it will stop automatically.
Advanced features
The focus does not adjust automatically.
● Focus is set to the manual mode.
H Set focus to the automatic mode. (
● The lens is dirty or covered with condensation.
H Clean the lens and check the focus again. (
Troubleshooting
The camera is a microcomputer-controlled device.
External noise and interference (from a TV, a radio, etc.)
might prevent it from functioning properly.
H
To solve the problem, follow the Instructions below at
first.
H
If the problem is not solved, reset the camera. (Refer to
“To reset the camera” below.)
H
If the problem still exists, please consult your nearest
JVC dealer.
8 To reset the camera
A Press and hold MENU and MODE for approx. 5
seconds. The power is turned off once and turned on
again automatically.
B If nothing happens, set the power switch to OFF and
remove the power supply (battery pack or AC adapter)
from the camera, then put it back again.
GZ-MC100PAL.book Page 33 Tuesday, December 28, 2004 1:04 PM