Connecting to a tv or vcr, Dubbing to a vcr, Pg. 25) – JVC LYT1341-001B EN User Manual
Page 25
BASIC OPERATIONS
EN
25
MasterPage: Basic_Right
A Black to S-VIDEO IN (Connect when your TV/VCR has
S-VIDEO IN and A/V input connectors. In this case, it is
not necessary to connect the yellow video cable.)
B Yellow to VIDEO IN (Connect when your TV/VCR has
only A/V input connectors.)
C Red to AUDIO R IN**
D White to AUDIO L IN**
* If your TV/VCR has a SCART connector, use the provided
cable adapter.
** Not required for watching still images only.
NOTE:
Set the video out select switch of the cable adapter as
required:
Y/C: When connecting to a TV or VCR which accepts Y/C
signals and uses an S-Video cable.
CVBS: When connecting to a TV or VCR which does not
accept Y/C signals and uses a video cable.
1
Make sure all units are turned off.
2
Connect the camera to a TV or VCR as shown in the
illustration.
3
Connect the VCR output to the TV input, referring to
your VCR’s instruction manual.
4
Turn on the camera, the VCR and the TV.
5
Set the VCR to its AUX input mode, and set the TV to
its VIDEO mode.
6
Start playback on the camera. (
To choose whether or not the following displays
appear on the connected TV
● Date/Time
Set [DATE/TIME] to [AUTO], [ON] or [OFF]. (
● Counter
Set [SCENE COUNTER] to [ON] or [OFF]. (
(Pressing INFO button also turns on/off the displays.)
NOTES:
● It is recommended to use the AC Adapter as the power
supply instead of the battery pack. (
● To monitor the picture and sound from the camera without
inserting a recording medium, set the camera’s power switch
to
, then set your TV to the appropriate input mode.
● Make sure you adjust the TV sound volume to its minimum
level to avoid a sudden burst of sound when the camera is
turned on.
● To connect the camera to a PC, refer to the software
installation and USB connection guide.
Dubbing to a VCR
1
Perform step
2
At the point you want to start dubbing, start recording
on the VCR. (Refer to the VCR’s instruction manual.)
3
To stop dubbing, stop recording on the VCR, then stop
playback on the camera.
Connecting to a TV or VCR
To TV or VCR
Open the cover.
To AV connector
S-Video/Audio/Video
Cable
(provided)
“Y/C” / “CVBS” Video
Out Select Switch
Cable Adapter*
GZ-MC100PAL.book Page 25 Tuesday, December 28, 2004 1:04 PM