John Deere OMPFP10808 - Manual (Page 22)

Setup
JS56696,0000503 ­19­02APR09­2/2
Change Widths—Used to enter implement width and
track spacing for guidance. Change implement width and
track spacing when changing implements. Implement
width and track spacing are independent of each other.
NOTE: IMPLEMENT tab will show HEADER for
Combines, ROW UNITS for Cotton Pickers,
and BOOM for Sprayer.
NOTE: Implement width may come from certain
controllers such as SeedStar.
Defining Implement Width and Track Spacing.
Implement Width and Track Spacing can be defined
two ways: enter the working width of the implement, or
enter the number of rows and the row spacing. To toggle
between these two, press the cm (ft)/(rows) button (A).
Implement Width cm (ft)/(rows)—enter total implement
working width or the number of rows and row spacing
distance.
This value is used to calculate total area when
documenting the operation.
Track Spacing—Used in guidance for how far each pass
is from the last pass. It is entered the same way as
Implement Width. For “perfect” guess rows, this distance
will be the same as Implement Width. To ensure some
overlap for tillage or spraying, or to account for some
GPS drift, you may choose to make the Track Spacing
somewhat less than the Implement Width.
Physical Width—The actual width of the entire implement
when being used in the field when the implement is raised.
It is sometimes larger than Implement Width.
PC1
1072
—UN—29FEB08
Change Widths
A—Toggle Button
B—Implement Width Input­Box
C—Track Spacing Input­Box D—Physical Width Input­Box
E—Row Width Input­Box
F— Row Width Input­Box
NOTE: Physical Width is not used for Implement Guidance.
There are certain value constraints to make Implement
Guidance work ­ refer to APPENDIX ­ Valid Configuration.
15­9 102110
PN=22