Invacare 1141466 - Manual (Page 3)

Part No 1141466 3 Walker Platform Attachment
Attaching/Adjusting the Arm Tube
NOTE: For this procedure, refer to FIGURE 2.
1. Loosen the arm tube adjustment knob, located
just below the arm pad.
2. Slide the arm tube into the slot underneath the
arm pad.
3. Adjust the arm tube to the desired position.
4. Securely tighten the arm tube adjustment
knob.
FIGURE 2 Attaching/Adjusting the Arm Tube
Adjusting the Angle or Tilt of the Walker Platform Attachment
ƽ WARNING
DO NOT apply full weight while adjusting the
angle or tilt - otherwise, injury may occur.
NOTE: For this procedure, refer to FIGURE 3.
Adjusting the Angle
NOTE: This adjustment changes the inward or
outward angle of the user’s arm to their torso on the
horizontal plane.
1. Loosen the adjustment knobs that secure the
support tube to the U‐clamps.
2. Turn the support tube until desired angle is
obtained.
3. Securely tighten the adjustment knobs.
Adjusting the Tilt
NOTE: This adjustment changes the tilt of the user’s
arm to the floor on the vertical plane.
1. Loosen the tilt adjustment knob.
NOTE: The tilt adjustment knob is located where the
support tube connects with the arm support.
2. Lift up or push down on arm tube to obtain the
desired tilt.
3. Securely tighten the tilt adjustment knob.
FIGURE 3 Adjusting the Angle or Tilt of the Walker
Platform Attachment
Arm Tube
Adjustment
Knob
Arm Pad
Adjustment
Knobs
U-Clamps
Arm Pad
Support Tube
Arm Tube
Tilt Adjustment
Knob
Front of
Walker