IBM T750 - Manual (Page 10)

8
7. Connect the DVI connector at the other end of the signal cable to the
DVI port located on the back of the graphics adapter. See picture below.
8. Replace the rear covers.
9. Connect the power cord to the power adapter first, then insert the plug
into a properly grounded electrical outlet.
10. Switch on the power source and your computer. To turn on the monitor,
push and release the power switch . To switch it off, push and release
the power switch again.
Switching on your Monitor
1. Switch on the power source and your computer.
2. Switch on your monitor by pushing and releasing the power switch
marked .
To switch off your monitor, push and release the power switch again.
3. Turn on the monitor and then the computer.
4. Run A UTO S ETUP
by following the instructions in the Device Driver
Installation section on page 9.
DVI
Signal Cable
graphics adapter
T750_E.fm Page 8 Monday, June 3, 2002 3:05 PM