Interquartz IQ333 - Manual (Page 16)

15
7. INSTALLATION
UNPACKING
The carton contains the following :
• Telephone body and handset
• Coiled cord and line cord
• This User Manual.
GENERAL SETTING-UP
1. Fit the COILED CORD to the appropriate sockets in the HANDSET and the telephone
base
2. Fit the LINE CORD to the rear socket and to your telephone network outlet
3. Set the Ringer Volume
4. See following sections to complete the installation.
LOCATION
The telephone should be placed on a desk, table or shelf where it is not likely to be
pushed off. If the unit is to be wall mounted, it should be seated securely on the WALL
MOUNTING BRACKET. Avoid excessive heat, damp, dust, direct sunlight, vibration, and
other appliances or devices that may transmit or emit electrical or electromagnetic radio
frequency noise or signals (e.g. computers, welders, pagers).
WALL MOUNTING
1. Fit the WALL MOUNT BRACKET (optional, not supplied) to the wall and attach the
WALL MOUNT BRACKET to the underside of telephone (see Figure 2)
2. To enable the HANDSET to be supported in the cradle, follow the procedure shown in
(Figure 2) to reverse the HANDSET RETAINER.
3. NOTE: The WALL MOUNT BRACKET and MODULAR WALL JACK illustrated in
(Figure 2) are available from your authorised Interquartz dealer and can be ordered as
"Wall Mount Kit No.3".
HEADSET
Connect a headset to the headset socket at the rear, and set the HEADSET POLARITY
SWITCH and HEADSET MIC ADJUST CONTROL described in this section.