IBM L170p - Manual (Page 19)

17
DE
UTSC
H
ENG
L
IS
H
FRANÇA
IS
E
S
P
AÑOL
IT
ALIANO
JA
P
A
NE
SE
COMPL &
W
ARR
Manual Setup
Normally, you can complete the setup procedure using A UTO S ETUP
; however,
if your screen image is still distorted after you perform A UTO S ETUP
or the
Installation CD does not run on your system, perform M ANUAL S ETUP
.
If the monitor is in standby
mode (STANDBY ON), it
might automatically turn off while
you are waiting for it to warm up.
1. Have your monitor turned on for about 15 minutes, until the monitor
warms up.
2. Display the image you most frequently use on the screen.
3. Press the OSD Enter button at the bottom of the monitor to display
the initial OSD menu.
4. Use an Arrow button ( or ) to select the Image Setup icon
and press the OSD Enter button to access the function.
5. Using an Arrow button ( or ), select MANUAL , press and then
press once to select Clock. Left and right arrow adjustment
indicators become illuminated ( see page 21).
6. Use the Arrow buttons to manually adjust to correct (as much as
possible) for noise in the video signal then press
to save the
changes.
7. Use an Arrow button to select Phase and press the button.
8. Use the Arrow buttons again to tune the image to your liking.
To save, press the
button two times.
9. When finished, press the Exit button two times to exit from the
OSD.
You have completed the monitor setup.
L170p_E.fm Page 17 Monday, February 24, 2003 11:12 PM