Supported platforms, Basic configuration, Installation requirements – IBM Netcool/OMNIbus Probe for Nortel CNM User Manual
Page 9: Updating the rules file, Installation requirements updating the rules file
Probe for Nortel CNM
3
Supported platforms
For details of the versions of HP-UX and Solaris on which this probe is supported, see the
following page on the IBM Tivoli Netcool Information Center:
Basic configuration
This section describes the basic configuration requirements for the Probe for Nortel CNM.
Installation requirements
Before running the probe, you must install the JDK 1.5 runtime libraries and the following
IBM Tivoli Netcool/OMNIbus patches in the following order:
1.
probe-compatibility-3.x
2.
probe-nonnative-base
3.
probe-nonnative-java
4.
nco_p_commandport-0
5.
probe-visibroker-support
Note:
These patches (except the VisiBroker patch) are available from the IBM Support
Site. To obtain the VisiBroker patch, you must contact IBM Support.
Updating the rules file
The Probe for Nortel CNM is supplied with a lookup table (Corba_3gpp2_
R6C1.lookup
). This file is installed in the following location:
$OMNIHOME/probes/includes/
This file is referenced in the rules file by the following command:
include "/opt/netcool/probes/includes/Corba_3gpp2_R6C1.lookup"
If the Tivoli Netcool/OMNIbus installation directory is different from /opt/netcool/,
you must update the rules file include statement accordingly.
Note: $OMNIHOME
cannot be used in the paths to the lookup files; you must enter the full
path to the Tivoli Netcool/OMNIbus installation directory.