Insignia NS-15LCD - Manual (Page 24)

23
NS-15LCD 15" LCD TV
www.insignia-products.com
Setting up in Component mode
To set up in Component mode:
1 Press MENU. The main menu opens.
2 Press CH /
to select Window, then press VOL / to open
the Window menu. The Window menu opens.
3 Press CH / to select the setting, then press VOL / to
adjust the setting.
Setting up in VGA mode
The native resolution of this TV is 1024 × 768, so your computer
should be set to this resolution when you connect it to the TV.
This TV only supports refresh frequencies of up to 60 Hz, so set your
computer accordingly. If you set it higher, the screen may flicker.
To set up in VGA mode:
1 MENU. The main menu opens.
2 Press CH /
to select Window, then press VOL / to open
the Window menu. The Window menu opens.
3 Press CH / to select the item you want to set, then press VOL
/ to adjust the setting.
Note Auto Config is not available in Component mode.
Note The Phase and Clock settings should be adjusted until you get a
good picture.
If you experience problems when adjusting the settings, set Auto
Config to Off, then reset it to On. The TV resumes its original
settings.
Auto Config
Phase
Off
60
80
80
80
80
90
60
Clock
H. Position
V. Position
Temp
Red
Green
Blue
NS-15LCD 15-inch TV - combined.fm Page 23 Wednesday, March 29, 2006 5:16 PM