Intel I/O Processor - Manual (Page 15)

Kernel—Linux - Debian
Linux-Debian Installation Guide Intel
®
I/O Processors June 2005
Order Number: 306507001US 15
Now test that the kernel boots. It is OK for there to be no root file system at this point. This is only
a trial test of the kernel.
Table 2 gives the parameter values for each of the SCD CRBs.
+Ethernet eth0: MAC address 00:0e:0c:52:98:20
IP: 10.0.1.8/255.255.255.0, Gateway: 10.0.1.9
Default server: 10.0.1.9, DNS server IP: 0.0.0.0
RedBoot bootstrap and debug environment [ROM]
Intel IOP RedBoot release
version 2.0-IOP-RedBoot
built 08:01:31; December 21, 2004
Platform: IQ80331 (Intel XScale
®
microarchitecture)
Copyright (C) 2000, 2001, 2002, Red Hat, Inc.
RAM: 0x00000000-0x08000000, 0x0001af78-0x07fd1000 available
FLASH: 0xc0000000 - 0xc0800000, 64 blocks of 0x00020000 bytes each.
RedBoot> load -r -v -b {kernel-load-addr} zImage.iq80331
Using default protocol (TFTP)
-
Raw file loaded 0x........-0x........, assumed entry at 0x........
RedBoot> exec {kernel-run-addr}
Using base address 0x........ and length 0x........
The boot tags are located at 0x00000100
Booting the kernel...
Uncompressing Linux.............................................................
Linux version 2.6.10-iop1 (user@labcomp) (gcc version 3.4.2) #1 Wed J5
CPU: XScale-IOP8033x Family [69054097] revision 7 (ARMv5TE)
CPU: D VIVT undefined 5 cache
CPU: I cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
CPU: D cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
Machine: Intel IQ80331
Memory policy: ECC disabled, Data cache writealloc
Table 2. Kernel Parameter Values for CRBs
{board} {kernel-load-addr} {kernel-run-addr} {ramdisk-load-addr} {ramdisk-run-addr}
iq8033x 0x01008000 0x01008000 0x00800000 0x00800000
iq80321 0x01008000 0xa1008000 0x00800000 0x00800000
ep80219 0x01008000 0xa1008000 0x00800000 0x00800000
iq31244 0x01008000 0xa1008000 0x00800000 0x00800000
iq80315 0x01008000 0x01008000 0x00800000 0x00800000