Diagram 4 – Impex MD-843 User Manual

Page 11

Text mode
Original mode

STEP 4

(See Diagram 4)

A.) Attach two Ø ¾” Leg Developer Bushings (#19) to the Leg Developer (#10). Attach the

Leg Developer to the Front Post (#9). Secure it with one M10 x 3 1/8” Allen Bolt (#35), two
Ø ¾” Washers (#40), and one M10 Aircraft Nut (#31). Do not over tighten the Nut and
Bolt. Make sure the Leg Developer is able to swivel.

B.) Insert two Foam Tubes (#17) halfway through the holes on the Leg Developer. Push four

Foam Rolls (#20) onto the Tubes from both ends. Plug four Foam Roll End Caps (#29)
into the ends.

C.) Attach a Spring Clip (#18) onto the weight post on the Leg Developer.

DIAGRAM 4