IBM iSeries 270 and 820 SENG-3002-01 - Manual (Page 17)

__ 4. DANGER
An electrical outlet that is not correctly wired could place hazardous
voltage on metal parts of the system or the products that attach to the
system. It is the customer’s responsibility to ensure that the outlet is
correctly wired and grounded to prevent an electrical shock.
(RSFTD201)
Plug the following power cords into an electrical outlet.
v System unit
Note: Do not power on your system unit at this time.
v System unit console
__ 5. Plug in and power on all attached devices, such as printers and displays.
Completing the installation
__ 1. Is your system unit an iSeries 270 or 820?
270 820
↓ Go to step 4.
__ 2. Look at the Function/Data display on the control panel. Refer to “System
unit control panel” on page 17.
__ 3. Does
01 B N V= S appear in the Function/Data display?
Yes No
↓
Do the following:
__ a.
Press the Increment/Decrement push button until 02 appears
in the Function/Data display.
__ b. Press the Enter push button on the control panel.
__ c. Press the Increment/Decrement push button until B appears
in the Function/Data display.
__ d. Press the Enter push button on the control panel.
__ e. Press the Increment/Decrement push button until
N appears
in the Function/Data display.
__ f. Press the Enter push button on the control panel.
__ g. Press the Increment/Decrement push button until S appears
in the Function/Data display.
__ h. Press the Enter push button on the control panel.
__ i. Press the Increment/Decrement push button until 01 appears
in the Function/Data display.
__ j. Press the Enter push button on the control panel.
01 B N S should appear in the Function/Data display. If it
does not, repeat steps 3a through 3i.
__ k. Go to step 6 on page 12.
__ 4. Look at the Function/Data display on the control panel.
__ 5. Does 01 B V= S appear in the Function/Data display?
Yes No
↓ Do the following:
Installation Instructions 11