Diagram 3 – Impex MWM900 User Manual

Page 10

Text mode
Original mode

STEP 3 (See Diagram 3)
A.) Place the Seat (#55) onto the Seat Support (#10). Secure it with two M8 x 1 5/8” Allen Bolts

(#69) and Ø 5/8” Washers (#78).

B.) Insert the Seat Support into the opening on the Main Base Frame (#1). Use a Lock Knob

(#32) to secure the Seat Support at desired height.

C.) Attach two

∅

1” x ½” Bushings (#34) to the Leg Developer (#9). Attach the Leg Developer to

the bracket on the Main Base Frame. Secure it with one M12 x 3 1/8” Allen Bolt (#71), two Ø
1” Washers (#76), and one M12 Aircraft Nut (#80). Do not over tighten the Bolt and Nut.
Make sure the Leg Developer is able to swivel on the Bolt.

D.) Insert two Foam Tubes (#40) halfway through the holes on the Seat Support and Leg

Developer. Push four Foam Rolls (#48) onto the Tubes from both ends. Cover each end
with a Foam Roll End Cap (#54).

DIAGRAM 3