Advanced setup —continued – Integra DTR-5.6 User Manual
Page 64
64
Advanced Setup
—Continued
Crossover
Note:
• If the crossover frequency is set to a low value, and the
program material doesn’t contain any sounds below
that frequency, the subwoofer will not output much
sound.
6
Use the Up and Down [
]/[
]
buttons to select “c. Center,” and
then use the Left and Right
[
]/[
] buttons to select:
Small:
Select if the center speaker is
small.
Large:
Select if the center speaker is
large.
None:
Select if no center speaker is
connected.
Note:
• If the Front setting in step 5 is set to
Small, the Large option cannot be
selected.
7
Use the Up and Down [
]/[
]
buttons to select “d. Surround,”
and then use the Left and Right
[
]/[
] buttons to select:
Small:
Select if the surround left and
right speakers are small.
Large:
Select if the surround left and
right speakers are large.
None:
Select if no surround left and
right speakers are connected.
Note:
• If the Front setting in step 5 is set to
Small, the Large option cannot be
selected.
8
Use the Up and Down [
]/[
]
buttons to select “e. Surround-
Back,” and then use the Left and
Right [
]/[
] buttons to select:
Small:
Select if the surround back
left and right speakers are
small.
Large:
Select if the surround back
speakers are large.
None:
Select if no surround back
speakers are connected.
Notes:
• If the Surround setting in step 7 is set
to None, this setting cannot be
selected.
• If the Surround setting in step 7 is set
to Small, this setting cannot be set to
Large.
9
Use the Up and Down [
]/[
]
buttons to select “f. SurrBack
Ch,” and then use the Left and
Right [
]/[
] buttons to select:
1ch:
Select if one surround back
speaker is connected.
2ch:
Select if two (left and right)
surround back speakers are
connected.
Continue with step 10 in the next col-
umn.
10
Use the Up and Down [
]/[
]
buttons to select “g. Crossover,”
and then use the Left and Right
[
]/[
] buttons to select a
crossover frequency.
Choose a crossover frequency suitable
for your setup. If you’re using a sub-
woofer, choose a crossover frequency
based on the diameter of your front
speakers. If you’re not using a sub-
woofer, use the diameter of any speaker
that you specified as Small.
Continue with step 11 on the next page.
Speaker cone
diameter
Crossover
frequency
Over 12 in.
(20 cm)
60Hz
70Hz
6-1/2 to 8 in.
(16–20 cm)
80Hz
90Hz
5-1/4 to 6-1/2 in.
(13–16 cm)
100Hz
110Hz
3-1/2 to 5-1/4 in.
(9–13 cm)
120Hz
130Hz
Under 3-1/2 in.
(9 cm)
150Hz
200Hz