Integra DTR-5.6 - Manual (Page 52)

52
Common Functions
This section explains functions that can be used with any
input source.
You can adjust the brightness of the display.
You can adjust the volume of each speaker while listen-
ing to an input source. These temporary adjustments are
cancelled when the AV receiver is set to Standby.
Notes:
• You cannot use this function while the AV receiver is
muted.
• Speakers that are set to No or None in the Speaker
Configuration cannot be adjusted.
■
Headphones
While a pair of headphones is connected, you can adjust
the volume of each headphone speaker, from –12 dB to
+12 dB each.
• These settings are stored when the AV receiver is set
to Standby.
You can temporarily mute the output of the AV receiver.
To unmute the AV receiver, press the remote control-
ler’s [Muting] button again, or adjust the volume. The
output is unmuted and the MUTING indicator goes off.
Muting is cancelled when the AV receiver is set to
Standby.
Tip:
You can choose how much the output is muted by using
the Muting Level preference (see page 69).
Setting the Display Brightness
Press the [Dimmer] button
repeatedly to select: Normal,
Dim, Dimmer.
Muting
CH Sel
Level – +
Sleep Dimmer
Display
Phones Dimmer Display
Press
[Receiver]
first
AV receiver
Remote
controller
Adjusting Speaker Levels
1 Use the remote controller’s
[CH Sel] button to select each
speaker, and use the [Level–] and
[Level+] buttons to adjust the vol-
ume.
You can adjust the volume of each
speaker from –12 dB to +12 dB
(–15 dB to +12 dB for the subwoofer).
Muting the AV Receiver
Press the remote controller’s
[Muting] button.
The output is muted and the MUTING
indicator flashes on the display.