Intel DX58SO User Manual

Page 40

Intel Desktop Board DX58SO Product Guide

NOTE

Using a DIMM with a voltage rating higher than 1.6 V may damage the processor.

To install a DIMM, follow these steps:
1. Observe the precautions in "Before You Begin" on page 27.
2. Turn off all peripheral devices connected to the computer. Turn off the computer

and disconnect the AC power cord.

3. Remove the computer’s cover and locate the DIMM sockets (see Figure 22).

Figure 22. Installing a DIMM

4. Make sure the clips at either end of the DIMM socket(s) are pushed outward to the

open position.

5. Holding the DIMM by the edges, remove it from its anti-static package.
6. Position the DIMM above the socket. Align the small notch at the bottom edge of

the DIMM with the keys in the socket (see inset in Figure 22).

7. Insert the bottom edge of the DIMM into the socket.
8. When the DIMM is inserted, push down on the top edge of the DIMM until the

retaining clips snap into place. Make sure the clips are firmly in place.

9. Replace the computer’s cover and reconnect the AC power cord.