InSciTek Microsystems Allworx Phone - Manual (Page 32)

Phone Guide
9 Wall Mounting (Optional)
Your phone is wall mountable and requires a wall mounting plate. The mounting plates are available from your
local telephone company or your local retailer.
Caution: If using a standard telephone wall mounting plate, DO NOT make any connection to the RJ 11
jack. This connection is intended for an analog phone and may cause damage to the Allworx
phone, voiding your warranty.
The mounting plate, similar to the one shown below, has mounting studs to receive the telephone base and is
positioned to secure the Allworx telephone flush to wall surface.
Collapse the Allworx phone base to the horizontal position and mount the phone over the mounting plate studs.
All power and RJ 45 cable connections should exit between the
phone body and the phone base and then be
routed to the network connection and/or a power connection.
Standard Telephone Wall Mounting Plate
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2007 InSciTek Microsystems, Inc. All rights reserved. Allworx is a registered trademark of InSciTek Microsystems. All other names may be
trademarks or registered trademarks of their respective owners.
Revised: March 28, 2007
Page 28