Invacare Wheelchair XP6500 - Manual (Page 9)

LABEL LOCATIONS
Part No. 1123839 9
LABEL LOCATIONS
Crossmember
Lower Frame
Tube
WARNING
DO NOT OPERATE WITHOUT
THE ANTI-TIP TUBES
INSTALLED. REV. 5/98 P/N 60106X144
Refer to Owner's Manual
for proper anti-tipper
setting.
1085379
WARNING
IMPORTANT NOTICE
The wheel locks on this wheelchair have been
pre-set at the factory to comply with the
Veterans Administration functional Standard
8320.01 of the Federal Register, paragraph
3.2.4.5.3. If these wheel locks do not meet
your needs, follow instructions below.
! CAUTION
Any wheel lock adjustments should embed
wheel lock shoe at least 1/8" into tire when
locked (3/16" on pneumatic tires).
INSTRUCTIONS FOR WHEEL
LOCK ADJUSTMENTS
1.Loosen wheel lock mounting fastener,
which runs through mounting bracket and
frame.
2.Slide clamp toward rear wheel until wheel
lock shoe is embedded into tire material at
least 1/8" when handle is engaged to the
lock position (3/16" for pneumatic tires).
3.Tighten mounting fastener to secure
mounting bracket in desired location and
recheck lock shoe embedding.
4.Inspect for correct locking action BEFORE
actual use.
00078X021-0394