Impex SR55 - Manual (Page 5)

ASSEMBLY INSTRUCTION
Tools Required to Assemble the Machine: Two Adjustable Wrenches and Allen
Wrenches
NOTE: It is strongly recommended this machine to be assembled by two or more
people to avoid possible injury.
STEP 1 (See Exploded Diagram)
A.) Attach a base Frame (#19) to the end of Main Base Frame (#4). Secure it with one
Bracket (#18), two M10 x 2 ¾” Carriage Bolts (#6), two
∅
¾” Washers (#9), and M10
Aircraft Nuts (#23). Repeat the same procedure to connect the other Base Frame
(#19) on the other side.
B.) Attach the Left Rear Vertical Frame (#12) to the Base Frame (#19). Align the holes to
the Bracket (#18). Secure it with two M10 x 2 ¾” Carriage Bolts (#6),
∅
¾” Washers
(#9), and M10 Aircraft Nuts (#23). Repeat the same procedure to install the other
side.
C.) Attach the Front Vertical Frame (#25) to the Base Frame (#19). Secure it with three
M10 x 5/8” Allen Bolts (#8) and
∅
¾” Washers (#9). Secure the Front Vertical Frame
(#25) to the Left Rear Vertical Frame (#12) with two M10 x 5/8” Allen Bolts (#8) and
∅
¾” Washers (#9). Repeat the same procedure to install the other side.
D.) Attach one Diagonal Support (#5) to the Main Base Frame (#4). Attach the other end
to the Rear Vertical Frame (#12). Secure the top and the bottom of the Diagonal
Support (#5) with two M10 x 2 ¾” Carriage Bolts (#6),
∅
¾” Washers (#9), and M10
Aircraft Nuts (#23). Repeat the same procedure to install the other side.
E.) Insert two Weight Holders (#13) into the two holes on the Rear Vertical Frame (#12).
Secure each Weight Holder with one M10 x 1” Allen Bolt (#24) and
∅
¾” Washer
(#9). Slide two Olympic Sleeves (#14) onto the Holders. Secure each Sleeve with a
M8 x ½” Allen Set Screw (#16). Repeat the same procedure to install the other side.
F.) Insert the Right & Left Bar Catches (#1) & (#20) into the selected holes on the Front
Vertical Frames (#25).
4