IBM 802.11g Wireless Broadband Router WRT-410 - Manual (Page 32)

- 27 -
Enabled/Disabled: Click to enable or disable SNMP. By default is disabled.
System Name: Displays the name given to the WRT-410.
System Location: Displays the location of the WRT-410 (normally, the DNS name).
System Contact: Displays the contact information for the person responsible for the WRT-410.
Community: SNMP system name for exchanging SNMP community messages. The name can be used
to limit SNMP messages passing through the network. The default name is
“public”.
Trap Receiver: Type the name of the destination PC that will receive trap messages.
3.6.2 Remote Management
This screen enables you to set up remote management. Using remote management, the WRT-410 can
be configured through the WAN via a Web browser. A user name and password are required to perform
remote management.
HTTP: Enables you to set up HTTP access for remote management.