Invacare WALKING TUTOR WT 200 - Manual (Page 3)

Part No 1141439 3 Walking Tutor
FIGURE 2 Removing the Boom Bearing Retainer
Attaching the Walking Tutor to the Lift
NOTE: For this procedure, refer to FIGURE 3 on page 4.
1. Install the pivot assembly to the mast.
2. Replace the boom bearing retainer.
3. Swing the boom back and push the bearing block into the top of the mast.
4. Secure the bearing block to the top of the mast with the existing socket head screws.
5. Ensure that the walking tutor armrests are positioned the correct way before
assembling (not shown).
6. Position the walking tutor in behind the actuator.
7. Rotate the walking tutor to match the boom orientation.
8. Using the socket head screws and locknuts, secure the walking tutor bearing block to
the pivot assembly (Detail “C” and Detail “D”).
DETAIL “A”
DETAIL “C”
Allen Key
DETAIL “B”
Mast
Socket Head Screws
Bearing Block
Mast
Boom Bearing
Retainer
Actuator and Boom
Kneepad
Mast