Insignia IS-EDPLTV42 - Manual (Page 20)

19
IS-EDPLTV42 42-inch ED TV
www.insignia-products.com
3 To select the device connected to the S-Video jack, press the
S-Video button.
4 To select the device connected to the YPbPr/YCbCr jacks, press
the YPbPr button.
5 To select the device connected to the VGA port (usually a
computer), press the PC button.
6 To select the device connected to the DVI jack, press the DVI
button.
Watching a TV program
To watch a TV program:
1 Turn on your ED TV.
2 Press the CH + or CH – button to tune to the channel you want to
watch.
Or
Use the number buttons to enter the channel number for the
channel you want to watch.
If you do not see the picture, make sure that your ED TV is set to TV
mode (see “Setting the video source” on page 18) and that the TV
signal source is set correctly (see “Selecting the TV signal source” on
page 18).
Adjusting the volume
To adjust the volume:
• Press the VOL + or VOL – button.
Creating a channel list
Your ED TV can scan for available channels and create a channel list
that includes only the channels that have a signal. When you use the
CH + and CH – buttons to scroll through channels, only the channels
in the list appear.
To create a channel list:
1 Press the Menu button to open the OSD.
2 Press the VOL + or VOL – button to select PRESET.
3 Press the CH + or CH – button to select RF INPUT.
4 Press the VOL + button to start the scan.
Using PIP and PBP modes:
You can watch two programs at the same time by using the PIP or
PBP modes.
To watch two programs at the same time:
1 Press the PIP button to cycle through PIP (Picture-in-Picture),
PBP (Picture-by-Picture), or Off.
2 Press the A button to switch control between pictures.