Icom IC-V85-T - Manual (Page 36)

23
5
REPEATER OPERATION
■
Offset frequency
When communicating through a repeater, the transmit fre-
quency is shifted from the receive frequency by an amount
determined by the offset frequency.
q Push
[FUNC] , then push [ SET ] (8) to enter SET MODE .
w Push [ Y Y ] or [ Z Z ] several times until “±” and offset frequency
appear.
e Rotate [VOL] to select the desired offset frequency.
• Selectable steps are the same as the pre-set tuning steps.
• The unit of the displayed offset frequency is “MHz.”
r Push [ ✱
ENT ] (or [CLR] ) to set the offset frequency and exit
SET MODE .
■
Subaudible tones
Some repeaters require subaudible tones to be accessed.
Subaudible tones are added to your normal signal and must
be set in advance.
q Push
[FUNC] , then push [ SET ] (8) to enter SET MODE .
w Push [ Y Y ] or [ Z Z ] several times until “rt” appears.
e Rotate [VOL] to select the desired subaudible tone.
r Push [ ✱
ENT ] (or [CLR] ) to set the selected tone and exit
SET MODE .
• Available subaudible tone frequencies (unit: Hz)
67.0
69.3
71.9
74.4
77.0 85.4
88.5
91.5
94.8
97.4
100.0
103.5 79.7
82.5
107.2
110.9
114.8
118.8
123.0
127.3
131.8 136.5
141.3
146.2
151.4
156.7
159.8
162.2 165.5
167.9
171.3
173.8
177.3
179.9
183.5 186.2
189.9
192.8
196.6
199.5
203.5
206.5 210.7
218.1
225.7
229.1
233.6
241.8
250.3 254.1
USING
SET MODE
USING
SET MODE