Assembly instruction – Impex COMPETITOR WM-343 User Manual

Page 5

Text mode
Original mode

ASSEMBLY INSTRUCTION

Tools required to assembly the machine:
Two Adjustable Wrenches

STEP 1

(SEE Diagram 1)

A.) Connect the two Rear Upright Beams (#1) by a Cross Brace (#25) in the Mid-span.
Fasten them by two M10x 2 3/8” Bolts (#14), four

∅

7/8” Washers (#13), one

Bracket (#12), and two M10 Aircraft Nuts (#15) on each side of the Cross Brace. DO NOT
tighten the nuts and bolts yet.

B.) Insert the Backrest Adjustment Bar (#10) through a selected hole to obtain desired
incline of Backrest.
C.) Insert two Bar Catches (#2) & (#6) into the selected hole on the Rear Upright

Beams (#1) to obtain the desired height to hold the Curl Bar (#3). Place two Spring Clips
(#4) onto the Curl Bar on both ends.

DIAGRAM 1