Intel DBPXA250 - Manual (Page 10)

10 DBPXA250 and DBPXA210 Development Platforms Specification Update
Summary of Changes
Note: Fixed refers to latest revision of the board and does not refer to earlier revisions. Some ECOs have
specific Intel
®
PXA250 and PXA210 applications processors stepping requirements.
Summary of BBPXA2xx Development Baseboard ECOs
ECO NO. Rev A Rev B
Refer
to:
Status ECO Description
1-9 These errata apply to a previously released stepping.
10 X X 12 Fixed “UCB1400 Generates Interrupts Incorrectly”
11 X X 12 Fixed
“USB Cable Attach/Detach Detection Interrupt Is
Constantly Asserted”
12 X X 13 No Fix “100-MHz SDRAM Failure”
13 There is no ECO 13.
14 X 13 Fixed “LCD Touch Screen Intermittently Fails”
15 X 15 Fixed
“New Philips UCB1400 Audio Codec on BBPXA2xx
Development Baseboard Requires Software
Change”
16 X X 15 No Fix “Conditional ECO To Use 3.3-V PCMCIA Cards”
17 X X 15 No Fix “Conditional ECO To Use The Expansion Port J26”
18 X X 15 No Fix “Conditional ECO For USB “Soft Connect” Support”
Summary of DCPXA250 Processor Card ECOs
ECO NO. Rev C Rev D
Refer
to:
Status ECO Description
1-2 These errata apply to a previously released stepping.
3 X 16 Fixed
“VCC_PLL And VCC_CORE Pin Voltage Must Be
Equal”
4-5 These errata apply to a previously released stepping.
6 X Fixed “50-MHz SDRAM Requires 0-ohm Resistors”
7 X X 17 Fixed “For ARM* Multi-ICE* JTAG Use”
8 X 18 Fixed “Excessive Oscillator Output Voltage to PEXTAL Pin”
9 X X 19 Fixed “Coin Cell Battery Issue”
10 X X 19 Plan Fix “Signal Integrity Problems On SDCLK”
11-12 These errata apply to a previously released stepping.
13 X X 20 Plan Fix “VCC Core Voltage Change”
Summary of DCPXA210 Processor Card ECOs (Sheet 1 of 2)
ECO NO. Rev A Refer to: Status ECO Description
1 X 21 No Fix “For Multi-ICE JTAG Use”
2 X 21 No Fix “MMC MMCLK Support”