Ives Heavy Duty Offset Top Pivot 7230F - Manual (Page 2)

26362 Rev. 3
Right hand installation shown;
left hand opposite
It is very important for installer to verify that center line of top pivot point lines up
with center line of bottom pivot point before final installation. Heel edge of door
must be beveled 1/8” in 2” as shown below.
NOTE !
Depth of mortise will vary
depending upon installation
and/or threshold height. *
Bevel heel edge
of door 1/8” in 2”
with 3/16” rad, typ
5/16”
8 mm
Edge of base
plate is flush with
edge of door
1-3/16”
30 mm 3/4”
19 mm
2-3/8”
60 mm
13/16”
21 mm * 1-1/4”
32 mm
to
*
26362-00