Adjusting the sound, Personalizing the projector menu display – InFocus XS1 User Manual
Page 41
Operation
41
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker.
Be sure you have made a correct connection to the projector audio input. See
for how the audio input is connected.
Muting the sound
To temporarily turn off the sound,
1.
Press Menu/Exit and then press / until the SYSTEM SETUP: Advanced
menu is highlighted.
2.
Press to highlight Audio Settings and press Mode/Enter on the projector
or remote control. The Audio Settings page displays.
3.
Highlight Mute and press / to select On.
Adjusting the sound level
To adjust the sound level,
1.
Repeat steps 1-2 above.
2.
Press to highlight Volume and press / to select a desired sound level.
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences.
The following settings do not affect the projection settings, operation, or
performance.
•
Menu Display Time in the SYSTEM SETUP: Advanced > Menu Settings
menu sets the length of time the OSD will remain active after your last button
press. The time length ranges from 5 to 30 seconds in 5-second increments.
Use
/
to select a suitable time.
•
Menu Position in the SYSTEM SETUP: Advanced > Menu Settings menu
sets the OSD position in five locations. Use
/
to select a preferred position.
•
Language in the SYSTEM SETUP: Basic menu sets your familiar language for
the On-Screen (OSD) Menus. Use
/
to select your language.
•
Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo
screen to be displayed during projector start-up. Use
/
to select a screen.