IBM 31P6260 - Manual (Page 14)

12
Manual Setup
Normally, you can complete the setup procedure using A UTO S ETUP , however,
if your screen image is still distorted after you perform A UTO S ETUP or the
setup diskette does not run on your system, perform M ANUAL S ETUP .
If the monitor is in standby
mode (STANDBY ON), it
might automatically turn off
while you are waiting for it to
warm up.
1. Have your monitor turned on for about 15 minutes, until the monitor
warms up.
2. Display the image you most frequently use on the screen.
3. Press the OSD Menu button at the bottom of the monitor to display
the initial OSD menu.
4. Use buttons ( - , + ) to select the IMAGE LOCK icon and press the
OSD Menu button to access the function.
5. Using buttons ( - , + ), select MANUAL , press and then press “ + “
once to select COARSE . Left and right adjustment indicators become
illuminated .
6. Use the buttons ( - , + ) to manually adjust to correct (as much as
possible) for noise in the video signal then press Exit to save the
changes.
7. Use buttons ( - , + ) to select FINE and press the button.
8. Use the buttons ( - , + ) again to tune the image to your liking.
9. When finished, press the Exit button four times to exit from the OSD.
You have completed the monitor setup.
T50_setup.fm Page 12 Thursday, August 9, 2001 11:09 AM