Motorola T6210 - Manual (Page 31)

T
a
lki
ng and Liste
n
ing
29
Setting the Interference Eliminator Code
You can specify a different code for each channel. To set a channel and code
combination, press \ and then press [ or ] to select the channel. Press \
again and then press [ or ] to select a code. Press M to exit the menu and to
save the channel and code combination. To set another channel and code
combination, repeat these steps.
Volume
To set the code, press \ twice until the code number display
begins to blink. Then press [ or ] to set the code. Press M to
save the code setting. To hear everyone on your channel, select
code
0 .
You can set the volume whenever you are not using a menu. Press
[
or ] until it’s just right. The display will show V and the volume
setting (
1
to
20
) with
1 being the lowest volume and
20
being the
highest volume.
Caution: Do not hold the radio too close to your ear when the volume is at a high
setting. This could cause hearing damage.
5
2 T6200 body.fm Page 29 Tuesday, February 20, 2001 3:36 PM