Memorex MPH2410 User Manual
Page 9
WALL MOUNTING THE UNIT (NO STANDARD WALL JACK)
1. Drill two holes with a vertical distance between the two marked positions of 3
15/16" (100mm).
2. Drive a screw into each of the holes. Tighten them to the end of the screw
lines, only leaving the smooth part of the screw
head outside the wall.
3. Install the wall mount bracket into the base unit
as previously discussed in Figures 3-6 on the
previous page.
4. Hang the unit onto the screws, then slide it down
firmly to fasten the base securely, as shown in
Figure 8.
UNINSTALLING THE WALL MOUNT
BRACKET
To remove the wall mount bracket from the base unit,
pull it back as shown in Figure 9.
HEADSET CONNECTION
One of the special features of your phone is that your handset could utilize a
headset (not included) for hands-free communication. Insert the small plug at the
end of your headset cord to the headset jack at the side of the handset. Follow the
procedures discussed in “Placing a Call” and “Receiving a Call” to place and
receive a call.
NOTE: The headset jack of your cordless telephone is compatible with 2.5 mm
headset plugs only. When you plug in the headset into the headset jack, it
automatically mutes the microphone and speaker of the handset. Unplug the
headset to return the handset to normal use.
8
INSTALLATION INSTRUCTIONS (CONTINUED)
Screws
Wall
Mount
Bracket
Base
(Side View)
Figure 8
Figure 9
MPH2410.O/M.QXD 3/7/03 9:35 AM Page 8