Memorex MPH2410 - Manual (Page 18)

17
SETTING THE PAUSE TIME
This unit enables you to change the number of seconds that a pause lasts when
using programmed pauses in your speed dial numbers or after your PBX number.
Set the Pause Time while in the Standby mode as follows:
Press and hold the VOICE MAIL/
MENU button for more than two
seconds; the Ringer Volume setting
will appear in the display.
1
Press the Scroll Down button ❶ seven
times or the 8 key button ❷; the Pause
Time setting will appear.
2
1
2
Press the EDIT/FLASH button to
change the setting; the Pause Time
setting will blink.
3
Press the Scroll Up ❶ or Down ❷
button to select the desired Pause
Time.
2
1
4
When the desired Pause Time setting
appears, press and hold the SAVE/
RE/PA button for more than two
seconds; a long beep will be heard to
confirm the setting has been saved.
5
You can continue with programming or
press the VOICE MAIL/MENU button
to return to the Standby mode.
6
SET-UP INSTRUCTIONS (CONTINUED)
MPH2410.O/M.QXD 3/7/03 9:35 AM Page 17