Multi-Tech Systems MT5600BR-V92 - Manual (Page 13)

2 Installation
13
MT5600BR-V92 User Guide
Installation
Perform the following procedure to install modem cards into the CC1600 rack. The installation process
involves:
1. Verify that the DIP-Switch settings conform to your application (dial-up or lease line).
2. Slide a modem card into one of sixteen available modem slots. Start by inserting a modem
into the left-most channel (slot #1) of the rack. The toggle switch should be at the bottom of
the card, with the component side of the card facing the right. The modem’s gold edge con-
nector is offset so that the modem cannot be inserted incorrectly. Continue installing modem
cards as necessary.
3. Connect one end of an RS232C Cable to the appropriate modem slot (DB25/25-pin connec-
tor-female) at the rear of rack. The other end of the RS232C cable is connected to the serial
port of the computer.
Note: Any cables connected to the computer must be shielded to reduce interference.
4. Plug one end of the RJ11 cable provided with the modem into the rack's RJ11 connector
(located on the back plane of the modem rack) and the other end into the phone-company-
provided RJ11 or RJ11W modular phone jack.
5. Verify the remote modem's current configuration settings with your MT5600BR-V92 in terms
of data compression, error correction, transmission rate, etc. (Refer to Chapter 4 for AT com-
mands).
6. Make sure modem and computer/terminal serial port baud rates are adjusted.
7. Proceed to Chapter 3 of this manual, or to your data communications software manual for
modem configuration.