Getting started, Insert sim card/battery – Siemens C62 User Manual
Page 7
Getting started
6
C62 en SUG, A31008-H6880-A1-2-7619 (15. December 2003, 14:46)
©
Siem
ens AG 2002
, I
:\Mob
il\L55\C
62_Z
w
ei
tau
sgabe\en\_v
on_i
tl\C62_
Startup.fm
Getting
started
Insert SIM card/battery
The service provider supplies you
with a SIM card on which all the im-
portant data for your account is
stored. If the SIM card is in credit-
card size, snap out the smaller seg-
ment and remove any rough edges.
• Remove the battery cover by
pressing top centre of the cover
and slide downwards.
• Insert the SIM card into the slot
with the contact area facing down-
wards
and push gently until it en-
gages below the holder (make
sure the angled corner is in the
correct position).
• Place the battery into the block of
the phone, with the contact area
facing down. Push the battery
carefully downwards.
• Slide the battery cover upwards
from the bottom of the phone, un-
til it latches into place.
Note
Always switch off phone before removing
the battery!
Only 3 V SIM cards are supported. Please
contact your service provider, if you have
an older card.