Marantz SR7400 - Manual (Page 12)

9
ENGLISH
3.
Close the cover until it clicks.
Note:
Do not use old batteries and new batteries
together. This can result in corrosion or
leakage of battery fluid.
The supplied manganese batteries are for
checking operation. Usage of alkaline batteries
is recommended.
When discarding batteries, be sure to follow
the local regulations for your area. Do not put
batteries in a fire.
REMOTE CONTROL RANGE
The distance between the transmitter of the
remote control and the IR SENSOR of the SR7400
should be less than 5 meters. If the remote control
is pointed in a direction other than the IR SENSOR
or if there is an obstacle between them, use of the
remote control may not be possible.
Remote-controllable range
LOADING BATTERIES
The life of the batteries used with the remote control
is about 4 months with normal use. Also be sure to
replace batteries earlier when you notice that they
are getting weak.
1.
Remove the back cover.
2. Insert the new batteries (AAA type) with
correct (+) and (–) polarity.
2 3 1 5 6 4 8 0 9 7
ME MO
CLEAR
DS S AM P AUX 2 AU X1 TAP E TUN ER CD CD -R M D VCR DVD TV
SO UR CE OFF ON/OF F PO WE R ON
D 4 D 5 D 2 M D1 D 3 D 5 OK VO L CH
PRE V MU TE MEN U EXIT GUID E TEST CH .SE L SU RR 7.1 CH AT T SP K- AB DIS P O SD SLE EP
1 2 LIG HT Lea rnin g R em ote C on trolle r RC1 400
Remote control unit (RC1400)
60 °
SR7400
Approx. 5 m
I NAME indicator
This is displayed when the remote control is in
renaming mode.
J LEARN indicator
This is displayed when the remote control is in
learning mode.
BATTERY REPLACEMENT INTERVAL
Under normal usage, alkaline batteries last
approximately four months. When the batteries
wear out, a battery mark is displayed on the LCD.
Although the remote control can still be used when
the battery mark is displayed, the batteries should
be replaced as soon as possible. The LCD
eventually starts to flash when buttons are
pressed, the remote control will be unable to
transmit signals or learn codes.
• This remote control uses non-volatile memory so
that the learned codes and macro programs are
retained even if the batteries are removed.
Reset the clock after replacing the batteries.
Safety Precautions for Batteries
B e s u r e t o a l w a y s o b s e r v e t h e f o l l o w i n g
precautions to prevent fluid leakage, overheating,
fire, breakage, accidental ingestion, and other
accidents.
• If the batteries are left unused for a long period
of time, the battery fluid may leak or the batteries
may corrode.
• Do not use the batteries in the remote control
with the plus and minus polarity reversed.
• D o n o t a t t e m p t t o r e c h a r g e , h e a t , o r
disassemble the batteries. Do not put the
batteries in a fire.
• Do not use the remote control with old batteries
or worn-out batteries inserted.
• Do not use different types of batteries or mix old
and new batteries in the remote control.
• If the remote control is not operating properly,
replace the batteries with new ones.
• If any of the batteries are leaking, completely
wipe up all leaked battery fluid, and then replace
the batteries with new ones.