Multitech MULTI MODEM II MT5600BA - Manual (Page 52)

4 AT Commands, S-Registers, and Result Codes
46
MultiModemII User Guide
Command: ** n Flash Memory Download
Values: n = 0, 1, or 2
Description: **0 Initiate download to flash memory at the last sensed speed.
**1 Initiate download to flash memory at 38.4K bps.
**2 Initiate download to flash memory at 57.6K bps.
Command: *B View Numbers in Blacklist
Values: n/a
Description: If blacklisting is in effect, AT*B displays a list of numbers for
which the last call attempted in the previous two hours failed.
Permanently forbidden numbers as defined by country re-
quirements do not appear in this list. If no numbers are black-
listed, only the OK result code is displayed.
Command: *D View Delayed Numbers
Values: n/a
Description: AT*D displays a list of delayed numbers, as defined in the *B
command, together with their delay times. If no numbers are
delayed, only the OK result code is displayed.
Command: #CBNy=[-]x Store Callback Number
Values:
y = 01–30
x = dialing string
Default: None
Description: Stores the callback dialing string x in memory location y. The
dialing string can include the digits 0 through 9 and any of the
following characters: #, *, comma (,), semicolon (;), W, A, B, C,
and D. Up to 30 characters can be used. Example:
AT#CBN01=9,16127853000
. If the optional - character precedes
the dialing string, and the caller appends the same character to
the password, the caller is immediately connected, and the
hangup and callback are skipped.
Command: #CBPy=x Store Callback Password
Values:
y = 01–30
x = password (6–10 characters)
Default: None
Description: Stores callback security password x in memory location y. The
password must have 6 to 10 characters. Example:
AT#CBP01=gilgamesh
.
Note: A direct connect password may not end with a hyphen (-).