Microtek MHP1-HD - Manual (Page 26)

26
C
HAPTER
4
Getting Started
This section explains some of the basic features to set up so you can begin using the PDP.
Turning the PDP On
1. Press the main power switch on the rear panel to supply
power to the PDP.
2. Press the POWER ( ) button on the remote control or on
the PDP unit to turn the PDP on.
NOTE:
If you need to disconnect power, first put the PDP into
standby mode by pressing the POWER ( ) button on the
remote control or on the PDP unit, then turn off power using
the main power switch on the rear panel of the PDP unit.
Selecting the Input Source
Before viewing TV or video input, familiarize yourself with the
source and channel selection as described in the following
sections.
• Selecting the TV Input Source
You can set the PDP to directly receive air signals, or to
receive cable signals from the cable attached to the Antenna
In input, if you have attached a cable from a rooftop antenna
or cable service provider.
1. Press the TV/VIDEO button on the remote control or the
SOURCE button on the PDP unit .
When the button is pressed, a list of the available input
sources appears on the screen for selection.
2. Press the UP/DOWN ( / ) button on the remote control to
select “TV1”, then ENTER to confirm your selection.
3. Press the ANT/CABLE button on the remote control to
toggle between AIR or CABLE input.
You can also set the TV input source using the on-screen
menu. See the section, “Adjusting TV Settings” in Chapter 5:
Using the PDP’s Features.