MGE UPS Systems EPS 7000 - Manual (Page 24)

1.5.3 Hidden Panel Indicators
The hidden panel is located behind the hinged cover, at the lowest pane of the front panel, refer to Figure 1-8.
The hidden panel includes the alphanumeric display and controls, and following controls and indicators, see Figure 1-
11.
Figure 1-11: Hidden Panel Alphanumeric LEDs and Pushbutton Indicators and Controls.
Hidden panel alphanumeric legend: (upper display, details on following page)
A Emergency Shutdown G Battery charging L Overload
B Rectifier/Charger on H Inverter fault M Bypass outside tolerance
C Rectifier/Charger fault I Battery discharged N Maintenance position
D Input Outside Tolerance J Inverter Desynchronized
F Battery temp. outside Tolerance K Transfer Fault
(lower display)
(port) Test connector fault Clear faults (audio) Alarm reset
1 Battery charge cycle 2 Return to float voltage (key) Security
3 Inverter sync/desync 4 Forced Transfer 5 Forced Shutdown
1.5.3.1 LED Alphanumeric Indicators
Fourteen alphabetically labeled LEDs provide detailed information on UPS status as follows:
A: Emergency shutdown
This red LED indicates that the emergency power off (EPO) or remote emergency power off (REPO) has been
activated. See section 2.10.1, Emergency power off.
B: Rectifier/charger on
This green LED indicates that the rectifier/battery charger is on.
Introduction
EPS 7000 Shared Systems
page 1 — 14
N M L K J I H G F E D C B A
1 2 3 4 5 fault