Multiquip MQ Multiquip MQPower 60Hz Generator DCA10SPX3 - Manual (Page 7)

DCA-10SPX3 A.C. GENERATOR — PARTS & OPERATION MANUAL — REV. #2 (01/17/11) — PAGE 7
RULES FOR SAFE OPERATION
■ NEVER touch output terminals during operation. This is
extremely dangerous. Always stop the machine when contact
with the output terminals is required.
CAUTION: CAUTION: CAUTION: CAUTION: CAUTION:
CAUTION: CAUTION: CAUTION: CAUTION: CAUTION:
■ Backfeed to a utility system can cause electrocution
and/or property damage. Do not connect to any
building's electrical system except through an approved
device or after building main switch is opened.
CAUTION: CAUTION: CAUTION: CAUTION: CAUTION:
■ Never use damaged or worn cables when connecting power
tools or equipment to the generator. Make sure power
connecting cables are securely connected to the generator's
output terminals, insufficient tightening of the terminal
connections may cause damage to the generator and
electrical shock.
CAUTION: CAUTION: CAUTION: CAUTION: CAUTION:
DO NOT touch or open any of the below
mentioned components while the generator
is running. Always allow sufficient time for
the engine and generator to cool before
performing maintenance.
Radiator
1. Radiator Cap - Removing the radiator cap while the
engine is hot will result in high pressurized, boiling water
to gush out of the radiator, therefore causing severe
scalding to any persons in the general area of the
generator.
2. Coolant Drain Plug - Removing the coolant drain plug
while the engine is hot will result in hot coolant to gush
out of the coolant drain plug, therefore causing severe
scalding to any persons in the general area of the
generator.
3. Engine Oil Drain Plug - Removing the engine oil drain
plug while the engine is hot will result in hot oil to gush
out of the oil drain plug, therefore causing severe
scalding to any persons in the general area of the
generator.