Multiplex Technology 8CH - Manual (Page 28)

25
4.12 ADVANCE MENU ___NETWORK 4.12 ADVANCE MENU ___NETWORK
Move the cursor to the “NETWORK”, and press ”ENTER”, then the screen will show
the following options.
1) NETWORK TYPE (STATIC):
Select NETWORK TYPE, and press “ ” or “ ” button to set the network
type as STATIC, and then press “ENTER” to go to the submenu of the
network. In the submenu of network type, use “
” or “ ” button to set all the
information needed in the DVR. See the illustration below.
2) NETWORK TYPE (DHCP):
This DHCP function need to be supported by router or cable modem network with
DHCP service. For detailed DHCP setting, please refer to P.37 and P.38
(Licensed Software AP).
3) NETWORK TYPE (PPPoE):
This PPPoE function need to have “username” and “password” from ISP supplier.
For detailed PPPoE setting, please refer to P.37 and P.38 (Licensed Software AP).
NOTE:
DHCP and PPPoE network types need to apply DDNS service to get “Hostname” to
correspond to dynamic IP address. For detailed DDNS setting, please refer to P.38.
NETWORK NETWORK
NETWORK TYPE STATIC
DNS 168. 95. 1. 1
PORT 0 0 8 0
STATIC STATIC
IP 60. 121. 46. 236
GATEWAY 60. 121. 46. 226
NETMASK 255. 255. 255. 254