Before switching on your tv, Switching the tv on/off, Power connection – Metz MF 55TK36 User Manual

Page 8: Connections to the rf input socket, How to connect other devices, Inserting batteries in the remote control handset

- 6 -

Before Switching on your TV

Power connection

IMPORTANT: The TV set is designed to op-

erate on 230V AC, 50 Hz.
After unpacking, allow the TV set to reach the

ambient room temperature before you con-

nect the set to the mains.

Connections to the RF input

socket

VHF /UHF

UWÃS@6SÃQ6I@G

867G@ÃUWÃ

Connect the aerial or cable TV plug to the

RF input socket located at the back of the TV

and connect the cable plug coming out from

the TV out socket located at the devices

(VCR, DVB etc.) to this socket as well.

How to connect other devices

IMPORTANT: Switch off the TV before con-

necting any external device.
Sockets for external connections are at the

back and front of the TV. For connection of

other devices via Euroconnector refer to the

manuals of the related devices.

Inserting batteries in the remote

control handset

Place the batteries in the right directions as

seen below.

Remove the battery cover located on the

back of the handset by gently pulling up-

wards from the indicated part.

Insert two

LR03 AAA

or equivalent type bat-

teries inside.

Replace the battery cover.

NOTE: Remove batteries from remote con-

trol handset when it is not to be used for a

long period.Otherwise it can be damaged

due to any leakage of batteries.

Switching the TV ON/OFF

To switch the TV on

Your TV will switch on in two steps:
1- Press the power button located on the front

of the TV. Then the TV switches itself to

standby mode and the RED LED located

below the TV turns on.

2- To switch on the TV from stand-by mode

either:

Press a digit button on the remote control so

that a programme number is selected,
or,
Press Programme Up or Down buttons on

the front of the TV or on the remote control,

so that last switched off programme is se-

lected.
By either ways the TV will switch on and the

RED LED will turn GREEN.

To switch the TV off

Press the stand-by button on the remote

control, so the TV will switch to stand-by

mode and the GREEN LED will become

RED,

or,
Press the power button located on the front

of the TV, so the TV will switch off and the

GREEN LED will turn off.