Metz MF 55TK36 - Manual (Page 23)

- 21 -
Copy Facility
Source selection for VCR recording.
• Select Features Menu in the Main Menu.
• Select AV-2 OUTPUT source pressing “ ” or
“ ” button.
Camera and Camcorder
To connect to Front-AV input
(FAV):
Connect your camera or camcorder at the
front side of your TV.
• Connect your equipment to the TV via VIDEO
(yellow), AUDIO R (red) and AUDIO L (white)
inputs. You should connect the jacks to the
input in the same colour.
Search for and store the test signal
of the video recorder
• Unplug the aerial cable from the aerial
socket “ANT” of your video recorder.
• Switch on your TV and put the video recorder
on the test signal. (See the handbook for
your video recorder.)
• Enter the Tuning menu via the Install menu.
• Search for the test signal of your video re-
corder in the same way as you searched for
and stored the TV signals. See Tuning,
Search and Store TV channels. Store the
test signal under programme number 0.
• Replace the aerial cable in the aerial socket
“ANT” of your video recorder once you have
stored the test signal.
Connect the decoder to the video
recorder
Some video recorders have a special
euroconnector for decoder.
• Connect a eurocable to the euroconnector of
your decoder and to the special euroconnector
of your video recorder. See also the hand-
book of your video recorder.
• To connect your video recorder to the TV, see
TV and Video Recorder section.
If you want to connect more equipment to
your TV, consult your dealer.
Connecting Headphones
Use the stereo headphone socket (HP) on
the lower front / right side of your TV, to con-
nect headphones.
Tips
Care of the Screen
Clean the screen with a slightly damp, soft
cloth.Do not use abrasive solvents as they
may damage the TV screen coating layer
Poor Picture
Have you selected the correct TV system? Is
your TV set or house aerial located too close
to the loudspeakers, non-earthed audio equip-
ment or neon lights, etc. ?
Mountains or high buildings can cause double
pictures or ghost images. Sometimes you
can improve the picture quality by changing
the direction of the aerial.
Is the picture or Teletext unrecognisable?
Check if you have entered the correct fre-
quency.
The picture quality may degrade when two
peripherals are connected to the TV at the
same time. In such a case, disconnect one
of the peripherals.
No Picture
Is the aerial connected properly? Are the
plugs connected tightly to the aerial socket?
Is the aerial cable damaged? Are suitable
plugs used to connect the aerial? If you are
in doubt, consult your dealer.
No Picture means that your TV is not receiv-
ing any transmission. Have you pressed the
correct keys on the remote control? Try once
more.
Sound
You can not hear any sound. Did you perhaps
interrupt the sound, pressing “
”key? Are
external speakers connected to the TV?