MTD BCR4 - Manual (Page 8)

FIGURE 2
FIGURE 1
4. If the D-handle was pre-installed, loosen its screws
just enough so that the handle slides and moves
easily.
5. While holding the unit in the operating position,
arrange the D-handle to the location that provides
you the best grip. See Figure 2.
6. Tighten the clamp screws evenly, until the
D-handle is secure.
ASSEMBLY INSTRUCTIONS
8
INSTALLING THE D-HANDLE
The D-handle may be pre-installed one some units. In
this case, all that is required is the loosening of screws
and D-handle adjustment. Tailor the handle to the
operator. Go to step 4 for adjusting the D-handle if it is
pre-installed.
1. Remove the screws and bottom clamp piece that
were installed on the D-handle for shipping.
2. Place the D-handle over the shaft housing and
onto the bottom clamp. See Figure 1. Place it a
minimum of 15.24 cm (6 inches) from the end of
the shaft grip.
3. Start the screws with a large flathead or T25
screwdriver. Do not tighten them until you make
the handle adjustment.
(4) Screws
Shaft
Housing
D-Handle Bottom
Clamp
Shaft Grip
Minimum 15.24 cm
(6 inches)